Watchguard Firebox X5-W Guía de usuario Pagina 55

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 234
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 54
User Guide 39
Configuration and Management Basics
Note
WSM v8.2 or later can manage Firebox X Edge (version 7.5) devices.
To manage Firebox X Edge e-Series (version 8.0) devices, you must use WSM v8.3.1.
1 To connect to the System Status page, type https:// in the browser address bar, and the IP
address of the Firebox X Edge trusted interface.
The default URL is: https://192.168.111.1
2 From the navigation bar, select Administration > WSM Access.
The WatchGuard System Manager Access page appears.
3 Select the Enable remote management check box.
4 From the Management Type drop-down list, select WatchGuard Management System.
5 To enable centralized Edge management through WatchGuard System Manager, click the Use
Centralized Management check box.
When the Firebox X Edge is under centralized management, access to the Edge configuration pages
is set to read-only. The only exception is access to the WSM Access configuration page. If you disable
the remote management feature, you get read-write access to Edge configuration again.
Do not select the Use Centralized Management check box if you are using WatchGuard System
Manager only to manage VPN tunnels.
6 Type a status passphrase for your Firebox X Edge and then type it again to confirm.
7 Type a configuration passphrase for your Firebox X Edge and then type it again to confirm.
Note
These passphrases must match the passphrases you use when you add the device to WatchGuard
System Manager, or the connection will fail.
8 In the Management Server Address text box, type the IP address of the Management Server if it
has a public IP address. If the Management Server has a private IP address, type the public IP
address of the Firebox protecting the Management Server.
The Firebox protecting the Management Server automatically monitors all ports used by the Management Server
and will forward any connection on these ports to the configured Management Server. No special configuration is
required for this to occur.
Vista de pagina 54
1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 233 234

Comentarios a estos manuales

Sin comentarios