Watchguard Firebox X5-W Guía de usuario Pagina 153

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 234
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 152
User Guide 137
Configuring Virtual Private Networks
Server, your Edge is a client of the Management Server in a client-server relationship. The Edge gets all
of its VPN configuration from the Management Server.
To configure a Firebox X Edge to allow WatchGuard System Manager access for the creation of VPN tun-
nels, see “Setting up WatchGuard System Manager Access” on page 38.
Manual VPN: Setting Up Manual VPN Tunnels
To create a VPN tunnel manually to another Firebox® X Edge or to a Firebox III or Firebox X, or to config-
ure a VPN tunnel to a device that is not a WatchGuard® device, you must use Manual VPN. Use this sec-
tion to configure Manual VPN on the Edge.
What you need for Manual VPN
In addition to the VPN requirements at the start of this chapter, you must have this information to create
a manual VPN tunnel:
You must know if the IP address assigned to the other VPN device is static or dynamic. If the other
VPN device is dynamic, your Firebox X Edge must find the other device by domain name and the
other device must use Dynamic DNS.
You must know the shared key (passphrase) for the tunnel. The same shared key must be used by
the two devices.
You must know the encryption method used for the tunnel (DES or 3DES). The two VPN devices
must use the same method.
You must know the authentication method for each end of the tunnel (MD5 or SHA1). The two
VPN devices must use the same authentication method.
We recommend that you write down your Firebox X Edge configuration, and the related information for
the other device. Use the Sample VPN Address Information table on the subsequent page to record this
information.
Vista de pagina 152
1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 233 234

Comentarios a estos manuales

Sin comentarios