Watchguard V2 Especificaciones descargar pdf (Pagina 36)

System Shutdown

This means that a serious problem has occurred and your

system has had to shut down. Please contact your installer

immediately or SecureNet on 1300 653 533

Billing Failed

Your alarm panel has failed when it called t

he 1900 number

for your monthly billing. Check that the phone line is

plugged in, there is a dial tone on the line and that your line

is enabled to call 1900 and 1300 numbers. Your control

panel will not work until your billing is successful.

High Level Radio Interference

System is experiencing a high level of interference, which

may prevent normal alarm activation.

External Siren Reboot The external siren has been turned off and back on again

External Siren Power Loss

There has been no power supplied t

o the External Siren for

15minutes. The External siren is running off the backup

battery

External Siren Battery Fail

The External Siren’s back up battery is outside normal

operating conditions and may be unable to run correctly in

the event of Main power loss.

External Siren Supervision fail

The External Siren has failed to communicate with the main

control unit for 24hours

External Siren Tamper

The Tamper switch on the external siren has changed

state. I.e. the siren has been removed from the wall.

If your alarm system is unable to contact the SecureNet DIGITAL MONITORING CENTRE it

will retry to send the message five more times at 25 second intervals. If unable to send the

message after these attempts, the message will be lost, so it is important to ensure that your

phone line is always connected to your alarm panel.

Message Format

The notification messages contain the following information:

Message

Date: The time and the date when the message is sent.

Detail: Provides the area, zone and event that caused the message to be sent

Account

Name: The name of the premises where the alarm is installed.

Address: The address of the premises.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 55 56

Sin comentarios

Watchguard V2 Especificaciones Pagina 36