Watchguard V2 Especificaciones descargar pdf (Pagina 30)

4.7. Stay Mode Entry Guard Sound

This selects the type of sound you would like for the stay mode alarm. There are 2

options. Normally, if the alarm is triggered in stay mode the alarm will sound 6 tones

when set to Entry Guard Tones. This is used to alert you if someone enters within

the stay mode protected area while you are at home. After hearing the entry guard

tones you may, if you choose, activate panic via the remote control. You can also

choose to have it sound Full Siren when an active stay zone is triggered. This only

applies to STAY mode.

Default

Entry Guard Tones

Option 1

Full Siren

TO CHANGE THE STAY MODE ENTRY GUARD SOUND

Safety Lock must be

off

Ensure Safety Lock has been turned off within the last 5

minutes. See Section 4.2.

Press both buttons

for 3 seconds

Enter Programming mode by pressing buttons 1 & 2

together for 3 seconds. The siren will beep 3 times to

confirm you have entered programming mode.

Press 1 time

Within 3 seconds, press Button 1 to select detector

programming. You will hear 1 beep as confirmation.

Press 1 time

Within 30 seconds, press both Button 1 & 2 together to

select the STAY mode entry guard sound. You will

hear 3 beeps as confirmation.

Continued on next page…

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Sin comentarios

Watchguard V2 Especificaciones Pagina 30