Watchguard Firebox III 2500 Especificaciones descargar pdf (Pagina 27)

Firebox System Area

Hardware Guide 23

Note that this procedure is possible only when a backup image is on the

backup area of the Firebox’s flash disk. There is no backup image on the

Firebox until you copy one there.

1 Click the Control Center Main Menu button (shown at

right), which is located on the upper-left corner of

Control Center.

2 Select Tools => Advanced => Flash Disk Management.

3 Select Restore Backup Image. Click Continue.

A verification prompt appears. Verify that the Management Station connects to

the Firebox Trusted interface either over the network (TCP/IP) or via a modem

using out-of-band management.

4 Click Yes.

The Connect To Firebox dialog box appears.

5 Use the Firebox drop list to select a Firebox or type the IP address

used by the Management Station to communicate with the Firebox.

Enter the configuration (read/write) passphrase. Click OK.

The Firebox copies the backup image from the backup area to the primary area of

its flash disk and reboots from the backup file.

1 2 ... 22 23 24 25 26 27 28 29 30

Sin comentarios

Watchguard Firebox III 2500 Especificaciones Pagina 27