Watchguard WGSENTINEL Manual de usuario descargar pdf (Pagina 17)

4. Programming

Turning the unit off and on enters programming mode. On each instance of

programming mode only a single device may be learnt in. To learn in another

device programming mode must be re-entered by turning the device off then

on again.

4.1. Adding New Remotes

TO ADD A NEW REMOTE

Turn the system off, by turning off the power supply.

Wait 10 seconds.

Turn the system on.

Press the remote button several times until the siren

starts beeping.

To test that a remote has been learnt successfully,

immediately attempt to arm the system with the

newly programmed remote. Refer to Section 3 of

this manual for remote operation instructions.

Your Watchguard Sentinel Home alarm System can only store a maximum of

FIVE wireless devices in its memory. If you learn in an 6th remote, the 1st

remote control will be erased. If you lose a remote control, or have one stolen,

or wish to delete a detector simply repeat the procedure above with one of

your remote controls at least 5 times. This will ensure that you have erased all

wireless devices (except the remote control being used in the procedure) from

the memory of your

Watchguard Sentinel Home Alarm System.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24 25

Sin comentarios

Watchguard WGSENTINEL Manual de usuario Pagina 17